◆OBD Codes

C0183

Tire Pressure Monitor System - Right Rear Low Pressure

Moderatesensor

Overview

The C0183 diagnostic trouble code means the chassis control module has identified a tire pressure monitor system - right rear low pressure problem. This code indicates that a chassis sensor or its circuit is not providing expected readings to the ABS/stability control system. Accurate sensor data is essential for the proper operation of anti-lock brakes, traction control, and electronic stability control, and a fault in this circuit can cause these safety systems to be disabled.

Symptoms

  • Vehicle pulls to one side during braking
  • Loss of traction control function
  • Cruise control will not engage
  • Unusual clicking or grinding noise from wheel area

Common Causes

  • Failed yaw rate or lateral accelerometer sensor
  • Tire pressure monitor sensor battery depleted
  • Damaged wheel bearing causing sensor misalignment
  • Brake pressure sensor failure

Diagnosis Steps

  1. 1Connect an OBD-II scanner and read all stored chassis trouble codes and freeze frame data
  2. 2Monitor wheel speed sensor signals using scan tool live data while driving
  3. 3Inspect the affected sensor and its wiring connector for damage or corrosion
  4. 4Check the sensor air gap and tone ring for damage, debris, or excessive wear
  5. 5Test the sensor resistance and voltage output with a multimeter; compare to specifications

Estimated Repair Cost

$100 — $500

Cost varies by vehicle, location, and repair shop. Includes parts and labor.

Commonly Affected Vehicles

Chevrolet CruzeHyundai ElantraToyota CorollaNissan Altima

Related Codes

C0155C0073C0015

More Sensor Codes

P0070Ambient Air Temperature Sensor Circuit
Low
P0071Ambient Air Temperature Sensor Range/Performance
Low
P0072Ambient Air Temperature Sensor Circuit Low
Low
P0073Ambient Air Temperature Sensor Circuit High
Low
P0074Ambient Air Temperature Sensor Circuit Intermittent
Low
P0095Intake Air Temperature Sensor 2 Circuit
Low

Frequently Asked Questions

The most common causes are a faulty sensor, damaged tone ring, excessive air gap, metallic debris on the sensor tip, corroded wiring, or a worn wheel bearing that allows the sensor to lose alignment with the tone ring.