Can engine codes cause permanent damage?

Yes, ignoring engine codes can lead to catastrophic engine failure. Issues like overheating, oil starvation, or persistent misfires can cause permanent internal damage if not addressed promptly.

How much does engine repair cost?

Engine repairs range from $200 for sensor replacements to $3,000+ for major internal repairs. In worst cases, a complete engine replacement can cost $4,000-$7,000 or more.

P0506

Idle Control System RPM Lower Than Expected

Moderateengine

Overview

The P0506 code indicates the engine control module has detected a idle control system rpm lower than expected condition. This is an engine-related diagnostic trouble code that may indicate a mechanical or control issue affecting the engine's operation. Depending on the severity, this code may require immediate attention to prevent engine damage.

Symptoms

Engine overheating
Check Engine Light (MIL) illuminated
Vehicle goes into reduced power mode
Engine running rough or stalling

Common Causes

Worn or damaged engine components
Low or dirty engine oil
Timing chain/belt wear or failure
Failed engine control module

Diagnosis Steps

1Connect an OBD-II scanner and read all stored trouble codes and freeze frame data
2Check engine oil level and condition; change if overdue
3Perform a compression and leak-down test
4Inspect related sensors and their wiring connections
5Listen for unusual engine noises indicating mechanical issues

Estimated Repair Cost

$200 — $3,000

Cost varies by vehicle, location, and repair shop. Includes parts and labor.

Commonly Affected Vehicles

Subaru WRXChevrolet CamaroBMW 3 SeriesDodge Charger

Related Codes

P0524 P0217 P0300

More Engine Codes

P0215Engine Shutoff Solenoid Malfunction

Critical

P0219Engine Overspeed Condition

Critical

P0263Cylinder 1 Contribution/Balance Fault

Severe

P0266Cylinder 2 Contribution/Balance Fault

Severe

P0269Cylinder 3 Contribution/Balance Fault

Severe

P0272Cylinder 4 Contribution/Balance Fault

Severe

Frequently Asked Questions

Engine codes can range from minor sensor issues to critical mechanical failures. If you notice overheating, knocking, or significant power loss, stop driving and have the vehicle towed to a mechanic.